Note that you can only use one device per daemon.
See also @ref{Device files}.
-@cindex GraphDumpFile
-@item GraphDumpFile = <@var{filename}> [experimental]
-If this option is present,
-tinc will dump the current network graph to the file @var{filename}
-every minute, unless there were no changes to the graph.
-The file is in a format that can be read by graphviz tools.
-If @var{filename} starts with a pipe symbol |,
-then the rest of the filename is interpreted as a shell command
-that is executed, the graph is then sent to stdin.
-
@cindex Hostnames
@item Hostnames = <yes|no> (no)
This option selects whether IP addresses (both real and on the VPN)
@c from the manpage
@table @samp
-@item ALRM
-Forces tinc to try to connect to all uplinks immediately.
-Usually tinc attempts to do this itself,
-but increases the time it waits between the attempts each time it failed,
-and if tinc didn't succeed to connect to an uplink the first time after it started,
-it defaults to the maximum time of 15 minutes.
-
@item HUP
Partially rereads configuration files.
Connections to hosts whose host config file are removed are closed.
New outgoing connections specified in @file{tinc.conf} will be made.
-@item INT
-Temporarily increases debug level to 5.
-Send this signal again to revert to the original level.
-
-@item USR1
-Dumps the connection list to syslog.
-
-@item USR2
-Dumps virtual network device statistics, all known nodes, edges and subnets to syslog.
-
-@item WINCH
-Purges all information remembered about unreachable nodes.
-
@end table
@c ==================================================================
@item dump graph
Dump a graph of the VPN in dotty format.
+@item purge
+Purges all information remembered about unreachable nodes.
+
+@item debug @var{level}
+Sets debug level to @var{level}.
+
+@item retry
+Forces tinc to try to connect to all uplinks immediately.
+Usually tinc attempts to do this itself,
+but increases the time it waits between the attempts each time it failed,
+and if tinc didn't succeed to connect to an uplink the first time after it started,
+it defaults to the maximum time of 15 minutes.
+
@end table