+
+Since pre5, tinc can operate in several routing modes. The default mode,
+"router", works exactly like the older version, and uses Subnet lines to
+determine the destination of packets. The other two modes, "switch" and "hub",
+allow the tinc daemons to work together like a single network switch or hub.
+This is useful for bridging networks. The latter modes only work properly on
+Linux and FreeBSD.
+
+The algorithms used for encryption and generating message authentication codes
+can now be changed in the configuration files. All cipher and digest algorithms
+supported by OpenSSL can be used. Useful ciphers are "blowfish" (default),
+"bf-ofb", "des", "des3", etcetera. Useful digests are "sha1" (default), "md5",
+etcetera.
+
+Support for routing IPv6 packets has been added. Just add Subnet lines with
+IPv6 addresses (without using :: abbreviations) and use ifconfig or ip (from
+the iproute package) to give the virtual network interface corresponding IPv6
+addresses. tinc does not provide autoconfiguration for IPv6 hosts, if you need
+it use radvd or zebra. Tunneling IPv6 packets only works on Linux, FreeBSD and
+possibly OpenBSD.
+
+It is also possible to make tunnels to other tinc daemons over IPv6 networks.
+In order to enable this feature the option "AddressFamily = any" or
+"AddressFamily = ipv6" must be added to the tinc.conf file. The host
+configuration files should contain IPv6 addresses for the "Address" variables,
+or hostnames which have an AAAA or A6 record.